During the construction or revamping of your roof, you can always go for an additional protective layer over the base roof layer. Same concept applies to the tin roofs as well. By incorporating an additional layer, tin roofs gain extra-strength to fight against the natural agents. The importance of employing a right technique cannot be neglected in the regular scheme of things. Most homeowners fail to get the desired results due to improper or faulty installation of the additional roof layer.

Based on the type and design of the roofing tin panels, the course of action may vary. The two commonly available varieties of roofing panels are the corrugated panels and the flat roofing panels.

The tin roofing panels must be placed over one another to render another layer over the base layer. Make sure that the two panels overlap by at least two ripples or six inches. An overlap of two ripples is generally recommended for corrugated tin roof panels. On the other hand, the sheets should overlap by at least six inches in case of flat tin roofing panels.

Align the upper tin panel over the base panel as per the manufacturer’s specification and start the nailing operation. Use a hand-held hammer to nail down the panels one by one. In order to prevent the panels from moving away, nail the top and bottom of the panels first. Once the setup looks steady, nail the other portions of the setting as well.

To prevent leaks and seepages, use nails with the rings. The rubber rings around each nail provide the required water-proofing to the concerned layer and minimize the possibility of water seepages.

If the participating tin roof panels are corrugated or interlocked then no other measure is required to strengthen the setup. However, the flat tin roofing panels require the additional operations further. Apply roofing cement over the whole upper layer to enhance the efficiency of the roof. Follow it up by applying a high-grade sealant solution over the seams. Finish off the task by soldering the gap between the tin roofing panels.

Leave the edge free to accommodate the third panel while installing the nails.

Keep an expert at your disposal throughout the length of the project.

Scott Rodgers is a fine expert who has been authoring on roofing contents for a long time now. His superb guidance has given motivation to a bunch of workers, ranging from San Bernardino Roofers (Need one? click here!) to San Clemente Roofers (Need one? click here!).